Introducing the Kia Stinger Short Ram Intake System by DC Sports. Crafted with precision and performance in mind, this intake system is engineered to elevate your driving experience to new heights.
Constructed from lightweight aluminum alloy, the intake tubes boast a sleek silver powder-coated finish that not only enhances aesthetics but also resists corrosion, ensuring lasting durability. DC Sports Air Intake Systems strike the perfect balance between heat protection and enhanced breathability, guaranteeing optimal engine performance.
Featuring a high-flow element filter that is both reusable and washable, this intake system ensures maximum filtration efficiency without compromising on airflow. The aluminum mandrel-bent piping optimizes airflow dynamics, further enhancing engine performance.
Designed and rigorously tested in the USA, this intake system is engineered for maximum performance gains. Experience improved flow and filtration, resulting in cooler intake temperatures and ultimately, enhanced engine performance.
Applications for the Kia Stinger 2.0T, this intake system is tailor-made to fit seamlessly into your vehicle, providing a perfect blend of form and function. With all the necessary hardware included, installation is hassle-free, allowing you to hit the road and unleash the full potential of your vehicle with confidence. Elevate your driving experience with the Kia Stinger Short Ram Intake System by DC Sports.
Technical details:
Heat shield is not compatible with G70 chassis
Included:
| Quantity |
Part Number |
Part Description |
| 1 |
DCSRP2000 |
SRI2000 Primary intake tube |
| 1 |
DCHS2000 |
SRI2000 Heat shield |
| 1 |
DCCP225-300 |
3-2.25” Reducing coupler |
| 3 |
DCCL300 |
3” clamp |
| 1 |
DCCL225 |
2.25” clamp |
| 25” |
DCTS_Trim |
Heatshield Trim |
| 11 |
DCTR_TRim |
Trim seal 11” |
| 1 |
DC-RAF35001 |
3.5” Filter Pack |
| 1 |
DCBADGE-L |
DC Badge Large |
| 2 |
DCDECAL |
DC Sports DECAL |
Install Guide:
1. Disconnect battery terminals
2. Remove two (2) 12 mm bolts holding strut bar
3. Remove the three (3) hoses going into the intake tube
4. Loosen clamps that goes from the rubber intake tube to the intake box and the throttle body and
gently pull it out.
5. Remove the three (3) 10 mm screws holding the intake box to the car and pull intake
box off car.
6. Locate the two (2) 10mm bolts securing the air duct and remove air duct from car.
7. Install rubber on heat shield. The thin rubber goes on the bottom of the heat shield while the thick
one goes on the top
8. Install heat shield on vehicle. Use two (2) 10 mm screws that you previously removed for this
install.
9. Assemble the intake tube by installing the filter kit and the coupler. Use clamps to secure
everything
10. Install intake onto car. Tighten down clamp from coupler to throttle body
11. Install the three (3) hoses onto the intake tube. Use the O.E. clamps
12. Install the strut bar back.
13. Double check your work! Make sure that you have no interference issue, clamps and hardware are
tight.
